Snap-on 5000-ST Manuale Utente Scaricare il pdf (Pagina 62)

MANUAL LOADER CHAPTER 6

6-61

IMPORTANT

The connector on single transducer cables contains the EEPROM calibration memory

chip. Never attempt to remove the connector from the transducer.

B- Hand Crank

Turn hand crank on the loader to apply torque. 2000 ft lbs of torque are generated with only 8 ft-

lbs of manual torque applied.

C- Reaction Block

The reaction block is positioned so that the reaction pins straddle the wrench handle at the hand

hold position specified on the wrench.

D- Linear Bearings

May be slipped over the reaction pins to reduce friction when testing very small or high resolution

electronic wrenches.

E- Reaction Pins

Hold the reaction block in place.

IMPORTANT

Adjustable stops on the reaction pins may be raised or lowered to level the wrench prior to

loading. Do not place a second stop above the wrench handle. It is normal for the wrench

handle to rise as it levels itself under load.

F- Drive Adaptor

A drive adaptor couples the wrench to the transducer. Low torque SURETEST series transducers

use an internal-internal drive adaptor and high torque SURETEST transducers may use an

adaptor/reducer.

G- Transducer (Accessory)

The loader accepts all SURETEST series single transducers directly. An optional 2000-400-02 4-

in-1 transducer can be mounted using a 2000-500-02 adaptor kit. For more information, refer to

Appendix A–Accessories.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 73 74

Nessun commento

Snap-on 5000-ST Manuale Utente Pagina 62